Konsistenciniai pneumatikos tepalai

Plastiniai pneumatinių įrankių tepalai

Rūšis

Darbinės temperatūros, ºC

Lašėjimo temperatūra, ºC

Pagrindas

Panaudojimas, savybės

 

 

Molyduval

Phoenix LKA

 

 

 

-60 iki +140

 

 

 

260

 

 

 

PAO

 

Specialus besilikoninis sintetinis pneumo tepalas

pneumatinių įrankių cilindrams, elastomerų tarpinėms sandarinti, įrankių remonto-montažo darbams. „Harmonic Drive“ reduktoriams                                      KPHC2N-60 pagal DIN 51502

Pakuotės : 100 gr ir 400 gr

Keičia

Graco Fusion Spray Gun Grease

Festo Special Grease silicone-free

Drėgmę surišantys specialūs pneumatiniai tepalai

Graco Fusion tepalai aukšto slėgio įrangai

Synthetic Pneumatic Grease

This multi-purpose PAO based grease is excellent for use in a wide variety of applications, especially where plastic compatibility is desired with the protection and wear prevention characteristics of a synthetic.

  • Long life, wide temperature range, and waterproof characteristics.
  • Suitable for lubrication of pneumatoc systems.
  • May replace silicone and O-ring greases in many applications.  

good anticorrosive properties * soft and smooth * long-time stable, effects long life-time and low cost * good water resistance * rel. good seal comtaibility, please ask for precise information in regard to your material * relative good compatibility with seals based on FPM and HNBR at temperatures up to 80°C, please check before application

for pneumatics

Pneumatinės įrangos tepimas konsistenciniu tepalu 

  • Solenoid valve

is the most important equipment in directional control unit of pneumatic system with precision design and high reverse frequency. In order to provide long-lasting lubrication and sealing performance, avoid “Start up from idle time”, specialty lubricant is required in solenoid valve to meet service temperature range from -30°C to 140°C and should be compatible with elastomers of O-ring, such as NBR, HNBR etc., good resistance to compressed air, which is oil contained or not. Low start torque fulfils high frequency reverse motion of O-ring on solenoid valve stem.

  •  Air cylinder

the execution equipment in pneumatic system transfers energy of compressed air to linear motion. In order to provide long-lasting lubrication and sealing performance, avoid stick-slip, retardance and “Start up from idle time”, specialty lubricant is required in air cylinder to meet service temperature range from -30°C to 140°C and should be compatible with elastomers of O-ring, such as NBR, HNBR etc., good adhesion property on O-ring and inner surface of cylinder with low evaporation but reasonable bleed percentage.

  • Sealing assembly

Each unit of pneumatic system contains rubber sealing parts, such as O-ring. Grease, which is compatible with elastomers, is required for assembling and sealing. Swelling or shrinking of sealing assembly would occur and result sealing failure if inappropriate lubricant is used